Thingiverse
Face Shield Small
door Neows6
0
Downloads
1
Likes
0
Makes
COVID-19 Mask Frame
This is a bit smaller than the most common masks and shields available but I needed one that would fit my Lulzbot Mini print bed.
I DO HAVE MY PRINTER BED SETTING IN THE MACHINE SETTING HIGHER THAN TYPICAL AT 156mm
I also set the distance between the pins that hold the plastic shield slightly wider than a standard spacing, I find the slight stretch helps hold it in place and keep a better form.
This is a bit smaller than the most common masks and shields available but I needed one that would fit my Lulzbot Mini print bed.
I DO HAVE MY PRINTER BED SETTING IN THE MACHINE SETTING HIGHER THAN TYPICAL AT 156mm
I also set the distance between the pins that hold the plastic shield slightly wider than a standard spacing, I find the slight stretch helps hold it in place and keep a better form.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
![[Mini Remix] Dual Filter Mask (COVID19, Coronavirus, etc.)](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Fassets%2Fe8%2Fdc%2Ffc%2Fac%2F0f%2Flarge_display_01.jpg&w=400&h=300)
