Slicer Discord
Fall Guy Lightbox – 3D-Druckmodell von MakerWorld MakerWorld
Signs & Logos

Fall Guy Lightbox

4 Downloads
4 Likes
3 Makes
Zum Modell
Am I the only one that remembers the little cartoon guy in the cut scenes between commecials breaks in the original TV series? I had someone come up to a vendor complaining about this light box cause the "movie was horrible". I enjoyed the movie, and I swear this predates the movie. Sits on a flat surface or hang up with #7 screws and mollies. Install a COB LED light strip to the inside perimeter. Apply hot glue to help keep the light strip in place. Add aluminum foil (duct) tape to the inside/back to help with light distribution. I use E6000 to glue the lid in place.
Kategorie
Signs & Logos
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

MattInDetroit veröffentlicht auch auf

36 zusätzliche Modelle auf 3 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen