Slicer Discord
Fall Guy Lightbox – 3D-printbaar model van MakerWorld MakerWorld
Signs & Logos

Fall Guy Lightbox

4 Downloads
4 Likes
3 Makes
Model downloaden
Am I the only one that remembers the little cartoon guy in the cut scenes between commecials breaks in the original TV series? I had someone come up to a vendor complaining about this light box cause the "movie was horrible". I enjoyed the movie, and I swear this predates the movie. Sits on a flat surface or hang up with #7 screws and mollies. Install a COB LED light strip to the inside perimeter. Apply hot glue to help keep the light strip in place. Add aluminum foil (duct) tape to the inside/back to help with light distribution. I use E6000 to glue the lid in place.
Categorie
Signs & Logos
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

MattInDetroit publiceert ook op

36 extra modellen op 3 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie