Thingiverse
First Layer Calibration Test
by TaylorsMake
63
Downloads
31
Likes
0
Makes
This is a Live z height test to help get an accurate first layer height tuned in.
The model steps up from 0.20 mm in 0.20 mm increments up to 1 mm in height.
Make sure to read the print instructions and understand before trying it.
The model steps up from 0.20 mm in 0.20 mm increments up to 1 mm in height.
Make sure to read the print instructions and understand before trying it.
TaylorsMake also publishes on
16 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
