Slicer Discord
Fish adder – 3D-Druckmodell von Thingiverse Thingiverse

Fish adder

0 Downloads
0 Likes
0 Makes
Zum Modell
When placing fish into a tank, it is hard to scoop them out of the bag after floating the bag. I instead like placing t a net over a pitcher, or something, and catching the fish for transfer into the tank. Unfortunately, this doesn't always work. There are times when the net moves, water slops over, etc. I don't like risking it, so I created this. It's nothing to look at, but it works. The side clip easily slides into whatever pitcher you use. I recommend, just in case, having some water in the pitcher before use to help keep it balanced/upright. There is a small rim at the top to help with any sloshing out. The net sits into the two indentations on the side box and a small chip clip can be used to stop it from rolling. It was a happy accident, but the water slowly drains so the fish are not completely left open until you remove the net.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen