Slicer Discord
Fish adder – 3D-printbaar model van Thingiverse Thingiverse

Fish adder

door Icebox-187
0 Downloads
0 Likes
0 Makes
Model downloaden
When placing fish into a tank, it is hard to scoop them out of the bag after floating the bag. I instead like placing t a net over a pitcher, or something, and catching the fish for transfer into the tank. Unfortunately, this doesn't always work. There are times when the net moves, water slops over, etc. I don't like risking it, so I created this. It's nothing to look at, but it works. The side clip easily slides into whatever pitcher you use. I recommend, just in case, having some water in the pitcher before use to help keep it balanced/upright. There is a small rim at the top to help with any sloshing out. The net sits into the two indentations on the side box and a small chip clip can be used to stop it from rolling. It was a happy accident, but the water slowly drains so the fish are not completely left open until you remove the net.
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie