Thingiverse
Five33 Switchback Pro bits
von xgoodvibesx
7
Downloads
7
Likes
0
Makes
Unify Tracer: Mount for a TBS Unify and Tracer antenna.
Foxeer Plain: 45 degree mount for Foxeer 1.7mm (13mm) lens
Foxeer v5: Same but with a slot for a tracer antenna
My Stick: My version of the classic stick turtle fin. A bit taller than the stock.
AXII 20 v2: 20 degree mount for an AXII v2 on an SMA mount. Angle is so the stiff part of the SMA connector doesn't press against the stack.
20x20 mount: just the right height to hold a 20x20mm ESC with gummies clear of the press nuts, with a little nut cover to prevent contact / shorting in a really hard crash. Trim out the lengthways part if you want.
30x30 is the same, for those of us who've Min Chan'd the frame.
Foxeer Plain: 45 degree mount for Foxeer 1.7mm (13mm) lens
Foxeer v5: Same but with a slot for a tracer antenna
My Stick: My version of the classic stick turtle fin. A bit taller than the stock.
AXII 20 v2: 20 degree mount for an AXII v2 on an SMA mount. Angle is so the stiff part of the SMA connector doesn't press against the stack.
20x20 mount: just the right height to hold a 20x20mm ESC with gummies clear of the press nuts, with a little nut cover to prevent contact / shorting in a really hard crash. Trim out the lengthways part if you want.
30x30 is the same, for those of us who've Min Chan'd the frame.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
