Thingiverse
Five33 TinyTrainer Turtle Mode Fin
door Haku3D
42
Downloads
21
Likes
0
Makes
A tried and tested turtle mode fin for your Five33 Tiny Trainer.
Print in TPU, 0.2mm layer height, no support.
Washers will be required to make the screw heads grip the fin strong enough during a crash.
I have included a new iteration of this fin, one that holds a Foxeer Lollipop antenna at the back, should print fine without support.
You can sell prints of this, but don't overcharge, and link back here.
Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.
Most FPV people may know me as licensetodrive on YouTube https://www.youtube.com/user/licensetodrive
Print in TPU, 0.2mm layer height, no support.
Washers will be required to make the screw heads grip the fin strong enough during a crash.
I have included a new iteration of this fin, one that holds a Foxeer Lollipop antenna at the back, should print fine without support.
You can sell prints of this, but don't overcharge, and link back here.
Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.
Most FPV people may know me as licensetodrive on YouTube https://www.youtube.com/user/licensetodrive
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
