Thingiverse
Flashforge 5M printer mods
por JungleTim
3
Descargas
5
Likes
0
Makes
A couple of parts for the popular 5M printer.
The custom drag chain end eliminates the filament runout sensor. (They don't even enable it from the factory) This is use with the factory enclose files WITHOUT the factory spool holder.
Install this part using the bolts that came with the enclosure kit in the spool holder location.
Remove the bowden tube from the filament sensor by removing the clip and pulling it out.
Feed the bowden tube thru the guide hole and thru the side of the enclusure top hole provided by Flashforge.
Set your favorite spool holder on the table and feed filament from your desktop or dryer.
The custom drag chain end eliminates the filament runout sensor. (They don't even enable it from the factory) This is use with the factory enclose files WITHOUT the factory spool holder.
Install this part using the bolts that came with the enclosure kit in the spool holder location.
Remove the bowden tube from the filament sensor by removing the clip and pulling it out.
Feed the bowden tube thru the guide hole and thru the side of the enclusure top hole provided by Flashforge.
Set your favorite spool holder on the table and feed filament from your desktop or dryer.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!