Thingiverse
Flashforge 5M printer mods
par JungleTim
3
Téléchargements
5
Likes
0
Makes
A couple of parts for the popular 5M printer.
The custom drag chain end eliminates the filament runout sensor. (They don't even enable it from the factory) This is use with the factory enclose files WITHOUT the factory spool holder.
Install this part using the bolts that came with the enclosure kit in the spool holder location.
Remove the bowden tube from the filament sensor by removing the clip and pulling it out.
Feed the bowden tube thru the guide hole and thru the side of the enclusure top hole provided by Flashforge.
Set your favorite spool holder on the table and feed filament from your desktop or dryer.
The custom drag chain end eliminates the filament runout sensor. (They don't even enable it from the factory) This is use with the factory enclose files WITHOUT the factory spool holder.
Install this part using the bolts that came with the enclosure kit in the spool holder location.
Remove the bowden tube from the filament sensor by removing the clip and pulling it out.
Feed the bowden tube thru the guide hole and thru the side of the enclusure top hole provided by Flashforge.
Set your favorite spool holder on the table and feed filament from your desktop or dryer.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !