Thingiverse
Flashlight Stand
von ctheroux
1
Downloads
3
Likes
0
Makes
This stand keeps a flashlight vertical. The allowed flashlight diameter is 32
mm.
Support material is not required. An infill of 10% is recommended.
This object main web page is:
http://www.ctheroux.com/flashlight-stand/.
This object was designed using Fusion 360.
You can request the source files on the page listed above.
mm.
Support material is not required. An infill of 10% is recommended.
This object main web page is:
http://www.ctheroux.com/flashlight-stand/.
This object was designed using Fusion 360.
You can request the source files on the page listed above.
ctheroux veröffentlicht auch auf
406 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
