Thingiverse
Flashlight wall mount
0
Download
1
Likes
0
Makes
requires:
- M8 nut and bolt (to tighten)
angles:
- 30 deg away from wall
- 35 deg left (or right)
notes:
- maximum flashlight handle diameter: 44mm
- flashlightholder-right was intended to shine to the bottom left (but you can rotate to any of 360 degrees by gluing it with another angle)
- flashlightholder-left was intended to shine to the bottom right (but you can rotate to any of 360 degrees by gluing it with another angle)
the mount plate here is very customized. In the end the holder just has to be glued to a flat surface. It can be the mounting plate here or something else.
- M8 nut and bolt (to tighten)
angles:
- 30 deg away from wall
- 35 deg left (or right)
notes:
- maximum flashlight handle diameter: 44mm
- flashlightholder-right was intended to shine to the bottom left (but you can rotate to any of 360 degrees by gluing it with another angle)
- flashlightholder-left was intended to shine to the bottom right (but you can rotate to any of 360 degrees by gluing it with another angle)
the mount plate here is very customized. In the end the holder just has to be glued to a flat surface. It can be the mounting plate here or something else.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
