Thingiverse
Flashlight wall mount
door forgevision66
0
Downloads
1
Likes
0
Makes
requires:
- M8 nut and bolt (to tighten)
angles:
- 30 deg away from wall
- 35 deg left (or right)
notes:
- maximum flashlight handle diameter: 44mm
- flashlightholder-right was intended to shine to the bottom left (but you can rotate to any of 360 degrees by gluing it with another angle)
- flashlightholder-left was intended to shine to the bottom right (but you can rotate to any of 360 degrees by gluing it with another angle)
the mount plate here is very customized. In the end the holder just has to be glued to a flat surface. It can be the mounting plate here or something else.
- M8 nut and bolt (to tighten)
angles:
- 30 deg away from wall
- 35 deg left (or right)
notes:
- maximum flashlight handle diameter: 44mm
- flashlightholder-right was intended to shine to the bottom left (but you can rotate to any of 360 degrees by gluing it with another angle)
- flashlightholder-left was intended to shine to the bottom right (but you can rotate to any of 360 degrees by gluing it with another angle)
the mount plate here is very customized. In the end the holder just has to be glued to a flat surface. It can be the mounting plate here or something else.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
