Slicer Discord
Flexi brush – Modelo 3D imprimible de MakerWorld MakerWorld
Other Hobby & DIY

Flexi brush

84 Descargas
64 Likes
40 Makes
Ver Modelo
English:It is a flexible brush that is good for cleaning and brushing on glue.Since it is made of TPU bristles, the glue can be easily removed after curing.This brush is good for the environment because it can be used over and over again.Fuzzy skin on the handle makes it easier to grip when brushing. The bristles are marked A & B, 13 pieces of A and 13 pieces of B, total of 26.Insert the retaining pin into the bottom of the frame (from the outside to the inside) so that it sticks out a little.Now put the bristles A and B, A and B... one after the other onto the pen and keep pushing them through until it is finally back in the frame.Deutsch:Diese Bürste bzw. dieser Pinsel eignet sich hervorragend zum Auftragen von Leimund zur Reinigung im Inneren ihres Fahrzeuges.Da sie aus TPU-Borsten besteht, lässt sich der Leim nach dem Aushärten leicht entfernen.Dieser Pinsel ist gut für die Umwelt, da er immer wieder verwendet werden kann.Fuzzy Skin am Griff sorgt dafür, dass er beim Bürsten griffi
Categoría
Other Hobby & DIY
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
¿Por qué?
diseño print-in-place · ensamblaje de 13 piezas
Print-in-place
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
TPU, Wood PLA
Postprocesado
Pegado
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

NxtGnPrtHub también publica en

7 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección