Slicer Discord
Flexi brush – 3D-printbaar model van MakerWorld MakerWorld
Other Hobby & DIY

Flexi brush

84 Downloads
64 Likes
40 Makes
Model downloaden
English:It is a flexible brush that is good for cleaning and brushing on glue.Since it is made of TPU bristles, the glue can be easily removed after curing.This brush is good for the environment because it can be used over and over again.Fuzzy skin on the handle makes it easier to grip when brushing. The bristles are marked A & B, 13 pieces of A and 13 pieces of B, total of 26.Insert the retaining pin into the bottom of the frame (from the outside to the inside) so that it sticks out a little.Now put the bristles A and B, A and B... one after the other onto the pen and keep pushing them through until it is finally back in the frame.Deutsch:Diese Bürste bzw. dieser Pinsel eignet sich hervorragend zum Auftragen von Leimund zur Reinigung im Inneren ihres Fahrzeuges.Da sie aus TPU-Borsten besteht, lässt sich der Leim nach dem Aushärten leicht entfernen.Dieser Pinsel ist gut für die Umwelt, da er immer wieder verwendet werden kann.Fuzzy Skin am Griff sorgt dafür, dass er beim Bürsten griffi
Categorie
Other Hobby & DIY
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
print-in-place ontwerp · 13-delige montage
Print-in-place
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
TPU, Wood PLA
Nabewerking
Lijmen
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

NxtGnPrtHub publiceert ook op

7 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie