Thingiverse
FrankenCNC
von I_am_me
14
Downloads
22
Likes
0
Makes
This is more of a showcase than something you can build from the files.
The goal was to make a CNC plotter using e-waste. It started when I disassembled some printers/scanners and found the motion systems. I immediately knew I wanted to build something out of it.
The electronics are very simple, an arduino running GRBL, a CNC shield and two stepper drivers. I use Inkscape to generate the G-code and Universal G-code Sender to stream it.
The parts you can see of the bed of the machine are all the iterations and failed prints created during this project.
The goal was to make a CNC plotter using e-waste. It started when I disassembled some printers/scanners and found the motion systems. I immediately knew I wanted to build something out of it.
The electronics are very simple, an arduino running GRBL, a CNC shield and two stepper drivers. I use Inkscape to generate the G-code and Universal G-code Sender to stream it.
The parts you can see of the bed of the machine are all the iterations and failed prints created during this project.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
