Slicer Discord
FridgeRx – 3D printable model from Thingiverse Thingiverse

FridgeRx

by stxal
2 Downloads
7 Likes
1 Makes
Go to Model
A week's worth of meds in a compact package (77mm diameter) . A 12mm x 3mm N52 neodymium magnet and a 10mm M5 hex head bolt hold the two halves together and attach the assembly to your fridge. You'll never forget where you left your meds again! The magnet needs to be glued into place with a drop of CA (super) glue (make sure it's fully seated on the bottom by giving it a tap and then holding it under pressure for 20 seconds). The bolt should be threaded into the lid until it's about the same dimension, or a little less, than the depth of the magnet. The container has eight compartments; one for each day of the week and one that's empty as an index (embossed bullseye). Detents align the aperture with each compartment and prevent the lid from randomly rotating. The detents are a bit stiff at first and require a few revolutions to "break-in". Alternately, a little candle wax rubbed on the hemispherical nubs on the underside of the lid works well.

Update 7/29: Added a base design with a
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Why?
significant post-processing
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 2/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Gluing, Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection