Slicer Discord
FridgeRx – 3D-Druckmodell von Thingiverse Thingiverse

FridgeRx

von stxal
2 Downloads
7 Likes
1 Makes
Zum Modell
A week's worth of meds in a compact package (77mm diameter) . A 12mm x 3mm N52 neodymium magnet and a 10mm M5 hex head bolt hold the two halves together and attach the assembly to your fridge. You'll never forget where you left your meds again! The magnet needs to be glued into place with a drop of CA (super) glue (make sure it's fully seated on the bottom by giving it a tap and then holding it under pressure for 20 seconds). The bolt should be threaded into the lid until it's about the same dimension, or a little less, than the depth of the magnet. The container has eight compartments; one for each day of the week and one that's empty as an index (embossed bullseye). Detents align the aperture with each compartment and prevent the lid from randomly rotating. The detents are a bit stiff at first and require a few revolutions to "break-in". Alternately, a little candle wax rubbed on the hemispherical nubs on the underside of the lid works well.

Update 7/29: Added a base design with a
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen