Slicer Discord
FridgeRx – Modelo 3D imprimible de Thingiverse Thingiverse

FridgeRx

por stxal
2 Descargas
7 Likes
1 Makes
Ver Modelo
A week's worth of meds in a compact package (77mm diameter) . A 12mm x 3mm N52 neodymium magnet and a 10mm M5 hex head bolt hold the two halves together and attach the assembly to your fridge. You'll never forget where you left your meds again! The magnet needs to be glued into place with a drop of CA (super) glue (make sure it's fully seated on the bottom by giving it a tap and then holding it under pressure for 20 seconds). The bolt should be threaded into the lid until it's about the same dimension, or a little less, than the depth of the magnet. The container has eight compartments; one for each day of the week and one that's empty as an index (embossed bullseye). Detents align the aperture with each compartment and prevent the lid from randomly rotating. The detents are a bit stiff at first and require a few revolutions to "break-in". Alternately, a little candle wax rubbed on the hemispherical nubs on the underside of the lid works well.

Update 7/29: Added a base design with a
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
postproceso considerable
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Pegado, Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección