Grappling Hook

I'm not sure what the costume was, but a buddy of mine needed a grappling hook for a cosplay, so I came up with this.Print the parts in the quantities listed below. You may need to drill or ream the dowel holes to 3mm if you use actual steel dowel pins. If you print the supplied pins you can just hammer them in with a small jewelers hammer.Quantities:1x Body A1x Body B1x Coil3x Tine A3x Tine BOptional:14x M3x12 (alternatively, you could use M3x12 dowel pins instead of printing theseAssembly:Main Body:Lightly tap two M3x12 dowel pins into Body A.Apply glue of choice to the mating surface of Body APress Body B onto the dowel pins. Ensure complete assembly with a small hammer, a bench vise, or clamps.Tines:Lightly tap four M3x12 dowel pins into Tine AApply glue of choice to the mating surface of Tine APress Tine B onto the dowel pins. Ensure complete assembly with a small hammer, a bench vise, or clamps.repeat for the next two sets of tinesFull Assembly:The full assembly can be a bit