Thingiverse
Hackerboxes 0089 Case
door TheRealQuantumStar
1
Downloads
1
Likes
0
Makes
This is an enclosure I made for the Hackerboxes 0089. It could also be used for a DIY Wardriving rig using the same components with perfboard or a custom PCB of the same size.
This design could probably use a little work, and the top needs to be glued onto the middle after the screen is inserted through the middle section and attached to the top, but hopefully this will be usable for other people.
I used supports for the top portion only. Everything else should print fine without them, but watch out for warping.
This design could probably use a little work, and the top needs to be glued onto the middle after the screen is inserted through the middle section and attached to the top, but hopefully this will be usable for other people.
I used supports for the top portion only. Everything else should print fine without them, but watch out for warping.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
