Thingiverse
Hypercube bank
por Old-Steve
0
Descargas
0
Likes
0
Makes
I remixed the Hypercube. Just a little.
I scaled it to 50X50X50. I posted a make of that.
The inner cube was the right size to trap a US quarter so I trapped 2 quarters inside the inner cube while it was printing.
Then I decided to remix it. I added a slot so I can slip a quarter into and out of the inner cube. If you don’t know the slot is there then it is kind of hard to see.
I got some pretty nasty droops under the bridges because I am printing without supports. But I cleaned them up.
Printed in PLA .2 layer 25% infill
I scaled it to 50X50X50. I posted a make of that.
The inner cube was the right size to trap a US quarter so I trapped 2 quarters inside the inner cube while it was printing.
Then I decided to remix it. I added a slot so I can slip a quarter into and out of the inner cube. If you don’t know the slot is there then it is kind of hard to see.
I got some pretty nasty droops under the bridges because I am printing without supports. But I cleaned them up.
Printed in PLA .2 layer 25% infill
Old-Steve también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
