Hypercube bank

I remixed the Hypercube. Just a little.

I scaled it to 50X50X50. I posted a make of that.

The inner cube was the right size to trap a US quarter so I trapped 2 quarters inside the inner cube while it was printing.

Then I decided to remix it. I added a slot so I can slip a quarter into and out of the inner cube. If you don’t know the slot is there then it is kind of hard to see.

I got some pretty nasty droops under the bridges because I am printing without supports. But I cleaned them up.

Printed in PLA .2 layer 25% infill