Thingiverse
HyperCube Evolution Height Adjustable Fan Duct
von 0scar
110
Downloads
54
Likes
0
Makes
This is a remix of the fan duct for the HyperCube Evolution. The original fan duct blew too much air against the hot end block so I wanted it to be height adjustable.
This fan duct distinguishes from the original in:
- slotted lugs so that the fan can be height adjusted according to the hot end clone height
- clipping of the sharp edge at the fan outlet to allow even further lowering of the duct.
I used PETG from ColorFabb to print the duct.
This duct works very well with the modular fan/e3d mount: https://www.thingiverse.com/thing:2777161
This fan duct distinguishes from the original in:
- slotted lugs so that the fan can be height adjusted according to the hot end clone height
- clipping of the sharp edge at the fan outlet to allow even further lowering of the duct.
I used PETG from ColorFabb to print the duct.
This duct works very well with the modular fan/e3d mount: https://www.thingiverse.com/thing:2777161
0scar veröffentlicht auch auf
56 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
