Thingiverse
HyperCube Evolution Height Adjustable Fan Duct
por 0scar
110
Descargas
54
Likes
0
Makes
This is a remix of the fan duct for the HyperCube Evolution. The original fan duct blew too much air against the hot end block so I wanted it to be height adjustable.
This fan duct distinguishes from the original in:
- slotted lugs so that the fan can be height adjusted according to the hot end clone height
- clipping of the sharp edge at the fan outlet to allow even further lowering of the duct.
I used PETG from ColorFabb to print the duct.
This duct works very well with the modular fan/e3d mount: https://www.thingiverse.com/thing:2777161
This fan duct distinguishes from the original in:
- slotted lugs so that the fan can be height adjusted according to the hot end clone height
- clipping of the sharp edge at the fan outlet to allow even further lowering of the duct.
I used PETG from ColorFabb to print the duct.
This duct works very well with the modular fan/e3d mount: https://www.thingiverse.com/thing:2777161
0scar también publica en
56 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
