Thingiverse

HyperCube Hall Effect Circuit Bracket

by Avintiquin

3 Downloads

1 Likes

0 Makes

This bracket allows a Hall Effect sensing circuit to be mounted onto an 8mm linear rod; I designed this with OnShape and TinkerCAD to replace the mechanical endstop on my HyperCube printer. The clamp portion of the bracket was taken from Tech2C's original HyperCube endstop bracket.

After attaching the bracket to the linear rod, I put a small magnet on top of the screw that used to press on the mechanical endstop and dialed it in.

Hardware needed:
(2x) M3x10 bolts (for attaching the circuit to the bracket)
(1x) M3x20 bolt (for securing the bracket to the linear shaft)
(1x) M3 standard or Nyloc nut (for linear rod)

Hall Effect Sensor Circuit (http://www.ebay.com/itm/Hall-Effect-Sensor-Circuit-3D-Printer-Endstop-RepRap-Proximity-Sensor-CNC-/221554609837?_trksid=p2385738.m2548.l4275)

NOTE: I provided a link as an example of the circuit in question; however, as long as it's similarly sized any should work.

UPDATED TO NEW VERSION AND PHOTO ADDED 11/1/17

8mm avintiquin bracket endstop hall effect linear rod magnetic sensor tech2c Z-Axis 8mm avintiquin bracket endstop hall effect linear rod magnetic sensor tech2c Z-Axis 8mm avintiquin bracket endstop hall effect linear rod magnetic sensor tech2c Z-Axis 8mm avintiquin bracket endstop hall effect linear rod magnetic sensor tech2c Z-Axis

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format