Thingiverse
HyperCube Hall Effect Circuit Bracket
par Avintiquin
3
Téléchargements
1
Likes
0
Makes
This bracket allows a Hall Effect sensing circuit to be mounted onto an 8mm linear rod; I designed this with OnShape and TinkerCAD to replace the mechanical endstop on my HyperCube printer. The clamp portion of the bracket was taken from Tech2C's original HyperCube endstop bracket.
After attaching the bracket to the linear rod, I put a small magnet on top of the screw that used to press on the mechanical endstop and dialed it in.
Hardware needed:
(2x) M3x10 bolts (for attaching the circuit to the bracket)
(1x) M3x20 bolt (for securing the bracket to the linear shaft)
(1x) M3 standard or Nyloc nut (for linear rod)
Hall Effect Sensor Circuit (http://www.ebay.com/itm/Hall-Effect-Sensor-Circuit-3D-Printer-Endstop-RepRap-Proximity-Sensor-CNC-/221554609837?_trksid=p2385738.m2548.l4275)
NOTE: I provided a link as an example of the circuit in question; however, as long as it's similarly sized any should work.
UPDATED TO NEW VERSION AND PHOTO ADDED 11/1/17
After attaching the bracket to the linear rod, I put a small magnet on top of the screw that used to press on the mechanical endstop and dialed it in.
Hardware needed:
(2x) M3x10 bolts (for attaching the circuit to the bracket)
(1x) M3x20 bolt (for securing the bracket to the linear shaft)
(1x) M3 standard or Nyloc nut (for linear rod)
Hall Effect Sensor Circuit (http://www.ebay.com/itm/Hall-Effect-Sensor-Circuit-3D-Printer-Endstop-RepRap-Proximity-Sensor-CNC-/221554609837?_trksid=p2385738.m2548.l4275)
NOTE: I provided a link as an example of the circuit in question; however, as long as it's similarly sized any should work.
UPDATED TO NEW VERSION AND PHOTO ADDED 11/1/17
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
