Thingiverse
Hypercube rigid stepper mount
por Moederbeer
20
Descargas
6
Likes
0
Makes
These stepper mounts are designed to reduce the motor tilt caused by tight belts on a hypercube. This in turn causes the belts to rub on the pulley flange. Deflection under load is simulated to be about one fourth of the original mounts. They have integrated mounts for the Y rods.
I printed these out of PETG with supports enabled 50% infill, 4 top/bottom layers and 4 perimeters.
I printed these out of PETG with supports enabled 50% infill, 4 top/bottom layers and 4 perimeters.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
