Thingiverse
Hypercube rigid stepper mount
door Moederbeer
20
Downloads
6
Likes
0
Makes
These stepper mounts are designed to reduce the motor tilt caused by tight belts on a hypercube. This in turn causes the belts to rub on the pulley flange. Deflection under load is simulated to be about one fourth of the original mounts. They have integrated mounts for the Y rods.
I printed these out of PETG with supports enabled 50% infill, 4 top/bottom layers and 4 perimeters.
I printed these out of PETG with supports enabled 50% infill, 4 top/bottom layers and 4 perimeters.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
