Thingiverse
Insert for 2020 Extrusion
por FrisbeeD
3
Descargas
0
Likes
0
Makes
The flat end sticks out enough to use CA glue or Acetone to attach to whatever you want.
Original intent was to attach after a print so I didn't need to waste filament on support.
Note: The fit is not tight. Probably will not hold vertically. I've included the .f3d file if you want to make changes.
Happy Making!
Original intent was to attach after a print so I didn't need to waste filament on support.
Note: The fit is not tight. Probably will not hold vertically. I've included the .f3d file if you want to make changes.
Happy Making!
FrisbeeD también publica en
13 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
