Thingiverse
Insert for 2020 Extrusion
von FrisbeeD
3
Downloads
0
Likes
0
Makes
The flat end sticks out enough to use CA glue or Acetone to attach to whatever you want.
Original intent was to attach after a print so I didn't need to waste filament on support.
Note: The fit is not tight. Probably will not hold vertically. I've included the .f3d file if you want to make changes.
Happy Making!
Original intent was to attach after a print so I didn't need to waste filament on support.
Note: The fit is not tight. Probably will not hold vertically. I've included the .f3d file if you want to make changes.
Happy Making!
FrisbeeD veröffentlicht auch auf
13 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
