Thingiverse
Insert for 2020 Extrusion
door FrisbeeD
3
Downloads
0
Likes
0
Makes
The flat end sticks out enough to use CA glue or Acetone to attach to whatever you want.
Original intent was to attach after a print so I didn't need to waste filament on support.
Note: The fit is not tight. Probably will not hold vertically. I've included the .f3d file if you want to make changes.
Happy Making!
Original intent was to attach after a print so I didn't need to waste filament on support.
Note: The fit is not tight. Probably will not hold vertically. I've included the .f3d file if you want to make changes.
Happy Making!
FrisbeeD publiceert ook op
13 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
