Slicer Discord
IPA Double Filter Funnel – 3D-Druckmodell von Thingiverse Thingiverse

IPA Double Filter Funnel

von Bob68
0 Downloads
0 Likes
0 Makes
Zum Modell
I use a stainless 100mm wide funnel with a standard coffee cone filter in a bottle. I then place the big funnel on top. Then a large basket coffee filter is added. Then i add the IPA to be filtered.
Normally even with a large blob of the jelly like residue in the IPA does not block the large filter. The liquid slowly drops out of the jelly over time saving lots of coffee cone filters.

I have only tried this a few times. So far i have only used one filter of each type every time.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen