Slicer Discord
IPA Double Filter Funnel – 3D-printbaar model van Thingiverse Thingiverse

IPA Double Filter Funnel

door Bob68
0 Downloads
0 Likes
0 Makes
Model downloaden
I use a stainless 100mm wide funnel with a standard coffee cone filter in a bottle. I then place the big funnel on top. Then a large basket coffee filter is added. Then i add the IPA to be filtered.
Normally even with a large blob of the jelly like residue in the IPA does not block the large filter. The liquid slowly drops out of the jelly over time saving lots of coffee cone filters.

I have only tried this a few times. So far i have only used one filter of each type every time.
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie