Thingiverse
Keyboard Stand
von Ninthendo64
10
Downloads
8
Likes
0
Makes
Just a stand I made for my Anne Pro 2 since i am not really using it anymore. The stand presumably works for other keyboards.
The part where the keyboard sits on is 1.9 cm long at 100%.
The stand holds the keyboard at an angle of 50 degrees.
The angle between the part where the keyboard sits on and the rest is 12 degrees.
You might want to lay the model down flat in your slicer.
The model is quite wide so you are able to balance the board with only one. If you want to use two (or more) to hold your board I recommend reducing the z height (while laying flat in slicer).
The part where the keyboard sits on is 1.9 cm long at 100%.
The stand holds the keyboard at an angle of 50 degrees.
The angle between the part where the keyboard sits on and the rest is 12 degrees.
You might want to lay the model down flat in your slicer.
The model is quite wide so you are able to balance the board with only one. If you want to use two (or more) to hold your board I recommend reducing the z height (while laying flat in slicer).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!