Thingiverse
Keyboard Stand
por Ninthendo64
10
Descargas
8
Likes
0
Makes
Just a stand I made for my Anne Pro 2 since i am not really using it anymore. The stand presumably works for other keyboards.
The part where the keyboard sits on is 1.9 cm long at 100%.
The stand holds the keyboard at an angle of 50 degrees.
The angle between the part where the keyboard sits on and the rest is 12 degrees.
You might want to lay the model down flat in your slicer.
The model is quite wide so you are able to balance the board with only one. If you want to use two (or more) to hold your board I recommend reducing the z height (while laying flat in slicer).
The part where the keyboard sits on is 1.9 cm long at 100%.
The stand holds the keyboard at an angle of 50 degrees.
The angle between the part where the keyboard sits on and the rest is 12 degrees.
You might want to lay the model down flat in your slicer.
The model is quite wide so you are able to balance the board with only one. If you want to use two (or more) to hold your board I recommend reducing the z height (while laying flat in slicer).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!