Thingiverse
Label Dispenser
por Amd3
17
Descargas
15
Likes
0
Makes
##A Simple Desktop Return Label Dispenser
A through bolt and nut holds the labels in place and makes swapping easier. Designed for "standard labels." Mine were printed by superiorlabels.com.
Design Note: Lower inside edges have fillet to provide a little extra support. Should be plenty sturdy enough for daily use with just PLA.
#NOTE
V5-STL has a larger nut for more tolerance on the fit. It leaves about 2mm of extra space for a loose fit. The v3 was too tight for me to connect. The nut is not needed as the bolt sits nicely in place without it.
A through bolt and nut holds the labels in place and makes swapping easier. Designed for "standard labels." Mine were printed by superiorlabels.com.
Design Note: Lower inside edges have fillet to provide a little extra support. Should be plenty sturdy enough for daily use with just PLA.
#NOTE
V5-STL has a larger nut for more tolerance on the fit. It leaves about 2mm of extra space for a loose fit. The v3 was too tight for me to connect. The nut is not needed as the bolt sits nicely in place without it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!