Thingiverse
Large spool holder
por pintokitkat
8
Descargas
19
Likes
1
Makes
This is a holder designed to fit onto the side of my replicator to allow me to use the large diameter spools that some filament comes on.
It has a slight angle to encourage the spool to slide towards the frame rather than off it, and a small diameter (34mm) to fit most spool holes.
Not given them much of a test yet, but they look quite funky!
It has a slight angle to encourage the spool to slide towards the frame rather than off it, and a small diameter (34mm) to fit most spool holes.
Not given them much of a test yet, but they look quite funky!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
