Thingiverse
Large spool holder
di pintokitkat
8
Download
19
Likes
1
Makes
This is a holder designed to fit onto the side of my replicator to allow me to use the large diameter spools that some filament comes on.
It has a slight angle to encourage the spool to slide towards the frame rather than off it, and a small diameter (34mm) to fit most spool holes.
Not given them much of a test yet, but they look quite funky!
It has a slight angle to encourage the spool to slide towards the frame rather than off it, and a small diameter (34mm) to fit most spool holes.
Not given them much of a test yet, but they look quite funky!
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
