Thingiverse
Led Ring Light
von Odin679
6
Downloads
8
Likes
0
Makes
Original found on printables.
Differences of the remix compared to the original
I made the difuser with one wall only and a cut so its easy to insert in the ring. Just leave the cut to the top and it wont be seen.
Added a 14.5mm hole to both bases to insert an on/off switch.
Rectanguler base is now a bit taller so it can fit a bluethooh led driver inside.
Made a cover to close the rectanguler base.
Only the rectanguler base needs supports
Differences of the remix compared to the original
I made the difuser with one wall only and a cut so its easy to insert in the ring. Just leave the cut to the top and it wont be seen.
Added a 14.5mm hole to both bases to insert an on/off switch.
Rectanguler base is now a bit taller so it can fit a bluethooh led driver inside.
Made a cover to close the rectanguler base.
Only the rectanguler base needs supports
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
