Thingiverse
Led Ring Light
by Odin679
6
Downloads
8
Likes
0
Makes
Original found on printables.
Differences of the remix compared to the original
I made the difuser with one wall only and a cut so its easy to insert in the ring. Just leave the cut to the top and it wont be seen.
Added a 14.5mm hole to both bases to insert an on/off switch.
Rectanguler base is now a bit taller so it can fit a bluethooh led driver inside.
Made a cover to close the rectanguler base.
Only the rectanguler base needs supports
Differences of the remix compared to the original
I made the difuser with one wall only and a cut so its easy to insert in the ring. Just leave the cut to the top and it wont be seen.
Added a 14.5mm hole to both bases to insert an on/off switch.
Rectanguler base is now a bit taller so it can fit a bluethooh led driver inside.
Made a cover to close the rectanguler base.
Only the rectanguler base needs supports
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
