Thingiverse
Electronics
Voir le modèle
LED Strip mount
149
Téléchargements
94
Likes
0
Makes
This is LED strip mount for white LED 8mm width.
I'm using it in Ender 3 Ikea Lack enclosure.
Glue is not needed, just small screws. LED strip holder can by easily "clicked in" to mount. But it's hard to remove holder from mount and corner parts are near to impossible, so think first :-) I recoment slide out if you need remove some parts from mount.
Led strip easily slide into holder.
Please don't use PLA it's very brittle.
I don't use corner parts because I'm so lazy to solder LED strip corner themselves and because they are not so practical but I upload them anyway :-)
I'm using it in Ender 3 Ikea Lack enclosure.
Glue is not needed, just small screws. LED strip holder can by easily "clicked in" to mount. But it's hard to remove holder from mount and corner parts are near to impossible, so think first :-) I recoment slide out if you need remove some parts from mount.
Led strip easily slide into holder.
Please don't use PLA it's very brittle.
I don't use corner parts because I'm so lazy to solder LED strip corner themselves and because they are not so practical but I upload them anyway :-)
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
