Thingiverse
Electronics
Model downloaden
LED Strip mount
149
Downloads
94
Likes
0
Makes
This is LED strip mount for white LED 8mm width.
I'm using it in Ender 3 Ikea Lack enclosure.
Glue is not needed, just small screws. LED strip holder can by easily "clicked in" to mount. But it's hard to remove holder from mount and corner parts are near to impossible, so think first :-) I recoment slide out if you need remove some parts from mount.
Led strip easily slide into holder.
Please don't use PLA it's very brittle.
I don't use corner parts because I'm so lazy to solder LED strip corner themselves and because they are not so practical but I upload them anyway :-)
I'm using it in Ender 3 Ikea Lack enclosure.
Glue is not needed, just small screws. LED strip holder can by easily "clicked in" to mount. But it's hard to remove holder from mount and corner parts are near to impossible, so think first :-) I recoment slide out if you need remove some parts from mount.
Led strip easily slide into holder.
Please don't use PLA it's very brittle.
I don't use corner parts because I'm so lazy to solder LED strip corner themselves and because they are not so practical but I upload them anyway :-)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
