Thingiverse
LED Work Light Stand
di thorgal
2
Download
11
Likes
0
Makes
This is a LED work light stand with a junction box to extend the power cord.
I bought a 20W LED light designed for wall installation, with mounting holes 65mm apart and a short cable, as it was three times cheaper than a similarly powerful halogen work light with a small stand. Even with the additional hardware and power cord, the total cost is still only two-thirds of the work light's price.
The stand is designed to either stand on its three legs or hang on a wall using the hole at the tip of one leg.
Outdoor LED lights typically have an IP rating of 65 to 68. I have attempted to seal the junction box against dust and dripping water, but no IP rating is guaranteed, as this will largely depend on the quality of your 3D prints.
I bought a 20W LED light designed for wall installation, with mounting holes 65mm apart and a short cable, as it was three times cheaper than a similarly powerful halogen work light with a small stand. Even with the additional hardware and power cord, the total cost is still only two-thirds of the work light's price.
The stand is designed to either stand on its three legs or hang on a wall using the hole at the tip of one leg.
Outdoor LED lights typically have an IP rating of 65 to 68. I have attempted to seal the junction box against dust and dripping water, but no IP rating is guaranteed, as this will largely depend on the quality of your 3D prints.
thorgal pubblica anche su
2 modelli aggiuntivi su altre 2 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
