Thingiverse
Light touch adaptive button
von scruss
7
Downloads
1
Likes
0
Makes
**will probably need trial and error to set hinge size - what is an interference fit on an Ender 3 is a loose running (aka hinge-falls-out) fit on a Prusa i3 mk.3s**
Modification of Davross's [XBox adaptive controller low cost/force buttons](https://www.thingiverse.com/thing:3211154):
1. Enlarged hinge to take 3 mm spring pin
2. Enlarged hole for button so that a wider variety of 12 mm buttons would fit
3. Shave a little off the back of the switch so that high speed FFF printers can still produce overhang and the switch will work
4. Printed on its side for stronger hinges.
Note that printing both parts on their sides - while resulting in stronger hinges - makes for a *much* longer print time.
Modification of Davross's [XBox adaptive controller low cost/force buttons](https://www.thingiverse.com/thing:3211154):
1. Enlarged hinge to take 3 mm spring pin
2. Enlarged hole for button so that a wider variety of 12 mm buttons would fit
3. Shave a little off the back of the switch so that high speed FFF printers can still produce overhang and the switch will work
4. Printed on its side for stronger hinges.
Note that printing both parts on their sides - while resulting in stronger hinges - makes for a *much* longer print time.
scruss veröffentlicht auch auf
92 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
