Thingiverse
Light touch adaptive button
door scruss
7
Downloads
1
Likes
0
Makes
**will probably need trial and error to set hinge size - what is an interference fit on an Ender 3 is a loose running (aka hinge-falls-out) fit on a Prusa i3 mk.3s**
Modification of Davross's [XBox adaptive controller low cost/force buttons](https://www.thingiverse.com/thing:3211154):
1. Enlarged hinge to take 3 mm spring pin
2. Enlarged hole for button so that a wider variety of 12 mm buttons would fit
3. Shave a little off the back of the switch so that high speed FFF printers can still produce overhang and the switch will work
4. Printed on its side for stronger hinges.
Note that printing both parts on their sides - while resulting in stronger hinges - makes for a *much* longer print time.
Modification of Davross's [XBox adaptive controller low cost/force buttons](https://www.thingiverse.com/thing:3211154):
1. Enlarged hinge to take 3 mm spring pin
2. Enlarged hole for button so that a wider variety of 12 mm buttons would fit
3. Shave a little off the back of the switch so that high speed FFF printers can still produce overhang and the switch will work
4. Printed on its side for stronger hinges.
Note that printing both parts on their sides - while resulting in stronger hinges - makes for a *much* longer print time.
scruss publiceert ook op
92 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
