Thingiverse
Lock Pick Handle.
door naswek
52
Downloads
32
Likes
0
Makes
Handles for lock picks. These are intended to be printed in pairs and glued on to DIY picks made from 12.5 mm (1/2 inch) wide feeler gauge stock. These measure 13 mm wide to leave room for sanding and to give a little flexibility on alignment.
Once assembled, the handle is a little thicker than Peterson's at 4.4mm plus the width of your pick and epoxy.
Once assembled, the handle is a little thicker than Peterson's at 4.4mm plus the width of your pick and epoxy.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
