Thingiverse
LORA32 case
por Alexander149
5
Descargas
6
Likes
0
Makes
A case for heltecs LoRa 32 (V3), with an additional compartement in the back to house a a 28mm x 46mm 3,7V Lithium Accu.
The assembled case is 27,4mm high, 35mm wide, and 68mm long (without antena).
The lid on the back should slide right in, and stay in place (if not, bend it gently over its length) if so desired, one can drill a hole through the center of the lid's semicircle, and secure it with a small screw.
The batterie's wire is pulled through an opening which leads to the connector of the board, on the other side of the case.
The assembled case is 27,4mm high, 35mm wide, and 68mm long (without antena).
The lid on the back should slide right in, and stay in place (if not, bend it gently over its length) if so desired, one can drill a hole through the center of the lid's semicircle, and secure it with a small screw.
The batterie's wire is pulled through an opening which leads to the connector of the board, on the other side of the case.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
