Slicer Discord
Mars Base – Modelo 3D imprimible de Thingiverse Thingiverse

Mars Base

por mtomalty
5 Descargas
5 Likes
0 Makes
Ver Modelo
This is the design for the Mars Base Challenge, it is designed as a box so you can see the set up above and below ground.

The base is built 5 meters underground to protect the astronauts from radiation. There are 4 main areas; the living quarters, laboratories and green house, the water pump and storage and the workshop.

The water pump is a drill which dills into the ice under mars surface and melt it for drinking water. The shop is for maintenance as well as a place to store the rover to keep it safe from the cold temperatures of Mars.

On the surface you will see the main entrance which connects to the 3 main partitions of the base and the entrance to the shop - which is an elevator - on the other side. There is solar panels set up for energy and the base can use the gases from the planet for extra power. Mars has quite a bit of carbon dioxide and nitrogen in its atmosphere which can be extracted through the vents in the main entrance's roof to be mixed into breathable air.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección