Thingiverse
Micro Limit Switch Mount
par paulmsam
17
Téléchargements
17
Likes
0
Makes
Needed to mount a limit switch for a project so made this :)
Its a very tight fit, but i did add holes that fit a strand of filament so that no screw is needed to hold the switch in place itself. It is a tight fix so use a pliers. With my printer it was overkill as the switch needed a reasonable amount of force to insert
It uses 3mm mounting screws
The arch printed fine on my printer, its there to allow the cables to come out either side once installed.
Its a very tight fit, but i did add holes that fit a strand of filament so that no screw is needed to hold the switch in place itself. It is a tight fix so use a pliers. With my printer it was overkill as the switch needed a reasonable amount of force to insert
It uses 3mm mounting screws
The arch printed fine on my printer, its there to allow the cables to come out either side once installed.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
